1. Launch the GDB monitor app, click the “+” button in “My Devices” screen. Swipe left to the step where you see the “Add device to network” button.2. Hold the “Add device to network” button for about 2 seconds. The ‘alternative way to setup’ button will show up. Click the ‘Alternative way to setup’ button.3.…
1. Go to your phone’s Settings.2. Navigate to Apps.3. Find and select the GDB monitor app.4. Tap on Storage & Cache.5. Choose the option to clear the storage and cache.6. Delete the monitor app from your phone.7. Reinstall the monitor app.8. Try logging in again.
There is a round hole on the GDB device. Use a pen or paper clip to hold the button inside for 15 seconds to factory reset the device. The LED will blink red with the 2 seconds interval when factory reset is successful. Delete GDB remote app from your phone. Install GDB remote app again…
1. Factory reset the device. Use a pen or paper clip to hold the button inside the hole. You will hear 7 beeps followed by a longer beep. Once the longer beep finishes, release the reset button. 2. Disconnect the batteries and reconnect batteries, you should hear two short beeps. 3. Turn on airplane mode…
When you are working in the garage and the garage door is left open for a long period time, you can silient the notifications from the GDB monitor app if you don’t want to get distracted by the notifications from the GDB monitor app. iPhone: With iOS 15, there’s a new feature called ‘Focus mode’. …
1. Make sure notification is enabled for the GDB monitor app. 2. If still not working, delete and reinstall the app. 3. If still not working. Delete the app data and delete the app. Then reinstall the app from the play store.
If you are using iOS devices. 1. Launch the monitor app. 2. Tap the “Devices” tab at the bottom. 3. Tap the row which shows your current garage door status. 4. Scroll down and you will see “Remove Device Notifications” button. Tap that button to remove notifications.
For iphone: 1. Factory reset the device. Use a pen or paper clip to hold the button inside the hole. You will hear 7 beeps followed by a longer beep. Once the longer beep finishes, release the reset button. 2. Disconnect the batteries and reconnect batteries, you should hear two short beeps. 3. Turn on…
Logout of the Monitor app. Then click ‘Forgot password’ to reset password. Here’s how to log out of the monitor app. For iPhone, click the “About” tab in the monitor app, then click “Logout”. For Android phone, click the ‘dot dot dot’ button > click ‘settings’ > click ‘Logout’ button.
1. Disconnect the old batteries. 2. Wait for 2 minutes. 3. Connect new batteries. 4. Open/close the garage door. You should get notifications. 5. It might take one hour or two to see battery percentage status update.